Imperial DS1 Manuel d'utilisateur télécharger pdf (Page 11)

- 10 -

4.1.1 East West Limit

On selecting Limit Setup button, the Limit

Setup menu will pop up. Pressing the E key on

the RCU continuously will take you to the

easternmost point. Press the OK key on the RCU.

The message Would you like to set East limit of

DiSEqC motor? will be displayed for your

confirmation. Place cursor on the OK button on

the screen and press OK key on the RCU to

confirm the East limit.

To set West limit, follow the same steps as East

limit.

4.1.2 Reset DiSEqC limit Place the cursor on

Reset DiSEqC Limit button and then press OK key on the RCU. The message Would you like to

reset limit for DiSEqC positioner? will be displayed for your confirmation. Select OK button by

pressing OK key on the RCU.

Select EXIT to finish antenna setup. The message Are you sure to change the configuration of

Antenna setup? will be displayed. Select OK button on the screen and then wait for the data to

be saved.

4.2 Antenna Setup  2) Fixed

1. Antenna : You can select a maximum of 16

antennas with the combination switches.

2. Type : Select your antenna type to be Fixed

3. Satellite : Select satellite you want.

4. LNB Type : Select your LNB type. If you have

universal LNB, select Univ.

5. LNB Freq. : Enter the proper LNB frequency

referring to your LNB using numeric key on

the RCU.

If you have a dual LNB, enter the proper value

in the value box.

6. Switches (22KHz Tone, DiSEqC) : You can select the switches with

which you want to configure the antenna.

7. C/Ku band control : You can select C/Ku band control by selecting the switch type.Select

EXIT to finish antenna setup. The message Are you sure to change the configuration of

Antenna setup? will be displayed. Please select the OK button on the screen and then wait

for the data to be saved.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Pas de commentaire

Imperial DS1 Manuel d'utilisateur Page 11